CONVERGE Pro 2 USB Expander

CONVERGE Pro 2 USB Expander

Expands the USB audio capability of a CONVERGE Pro 2 mixer by providing an additional USB audio interface with 2×2 channels.

Description
  • 2 input channels (L&R) and 2 output channels (L&R) of 48kHz, 24-bit professional-quality audio.
  • Useful for Unified Communications, video conferencing, audio playback and recording, and more.
  • Can daisy-chain up to three USB expanders per CP2, and can also be daisy-chained with other P-link devices.
  • Can be placed up to 200’ (60m) from CP2 or other P-link devices, extending a P-link chain.
  • Compact form factor (1/3 RU) and flexible mounting (rack, under-table, wall, or ceiling).
  • P-link or PoE Injector for power and Serial connection for control interface.
Specification
USB AUDIO

Port Type: USB-B Connector
Audio: Digital audio, 2 x 2 bidirectional channels
Sample Rate: 48 kHz
Sample Bit Depth: 24 Bit
Compatible: USB 2.0, USB 3.0
USB Cable Distance: 16 feet (5 meters)
Compatible: Windows & Mac OS devices
P-LINK PERIPHERAL BUS

Ports Type: RJ-45 (Cat5e or Cat6)
P-Link In & Out: Proprietary Peripheral Bus
PoE In: P-Link In Port PoE IEEE802.3AF
Audio: Up to 3 USB Expander units
Cable: Solid core 24AWG, factory terminated Cat 5e or Cat 6 cable
Distance: Up to 200 feet (60 meters)
Daisy-chain: Up to 3 USB Expander units + Up to 3 Beamforming Microphone Array 2 units + Up to 3 GPIO Expander units + Up to 3 DIALOG 20 Wireless Mic Receiver units in the P-link chain
CONFIGURATION & ADMINISTRATION SOFTWARE

Pro CONSOLE software
MOUNTING

Rack-shelf mount
Underneath table mount
Wall mount
Ceiling mount
RS232

Type: 3 Position (Tx, Rx, Gnd) 3.81mm Grey Header, Male, Phoenix type Euro block connectors
Support: Serial commands
Connection: Connect with Touch Panel Controller for CP2, third-party control devices
POWER SELECTION SWITCH

Sensor Type: Slide Switch
Toggle toward P-Link to power device by P-Link
Toggle toward PoE to power device by PoE Injector
PoE In PORT

Port Type: RJ-45 port
PoE: 802.3af or 802.3at PoE/PoE+ injector input
FRONT PANEL LEDs

POWER LED:
– Off: Not powered
– Solid Blue: Powered ON
STATUS LED:
– Off: No P-Link plugged in
– Solid Blue: P-Link plugged in and system working normally
– Flashing Blue: Locate mode initiated from Pro CONSOLE Software
– Red: Error condition

Related products

1